Exhaust manifold

[Malcolm B]

1984 turbo exhaust manifold. Anybody know if they can be welded? Also, which way do the securing clamps go on as one side has a flat edge.

[JezZedexE1]

Check this post. viewtopic.php?p=183141&hilit=exhaust+clamp#p183141

Should have most of the information you require regarding fitting them. Manuals are in the download section.

Would need to see an image or two to see the area that needs welding. Might be possible.

[Malcolm B]

Thanks. I'm struggling to post a couple of pics.
I tried to edit my original post and add pics but says file too big. Tried also to add one pic, same message saying file too big. Obviously I'm doing something wrong here!

[youngblood]

I find it easy to open the photo in paint then resize, pixels to 1000 works every time

[billybluesky1]

Iv`e got to admit i can`t be arsed trying to post pictures, microsoft seem to hi jack any pictures I upload from my phone , then when I actually find them re sizing etc, Its probably not too bad if you use computers on a regular basis but re learning every time , pass, can it be done easier on a phone? thats the only way i can use moonpig.