Dog bones which ones

[Mrredt]

I have just put in a k1 suzuki 600 rear arm
Has anyone got to the bottom of the length needed
I just tried some suzuki bandit 1200 mk2 fit ok but shock spring is touching the swinging arm at tge back engine side
Any iddes what to use
I would appreciate a point in the right direction

[Charlie @ Evergreen]

When did my conversion used two bars with multi slot holes to get a close ride height correct. Then made a set of cold roll steel tube heim joint left right adjustable arms to tune with. Do not think you can find a exact fit length dog bones. Good luck

[Mrredt]

Thanks for the reply i was thinking of rod end to get the right height i want
The shock angle is the issue
I either make an adapter to move the shock or sand it out of the arm for clearance
Unless there is a lower pivot arm we can use