USB Map for 370cc injectors ?

[paxo]

Anyone got a baseline map i can use as a good starting point for a USB PC111 ? I found some on here that were similar and thought would be ok but they are the serial maps and wont work on my USB setup.
Bike is currently running 810 kit, 370cc injectors, racemode,adjustable boost, gpz1100 throttle bodies, very short 2" bore exhaust, K & N

Ta

[kawasakiman542]

You could enter it manually..also what size turbo are you using?
http://www.750turbo.com/forum/viewtopic ... aps#p52086

[paxo]

cheers.....it's currently got an IHI turbo fitted, slightly bigger than the hitachi. I was hoping for a map as it all looks a bit complex this stuff ! If I can get hold of a USB map that works I can ride the bike to my local DYNO guy and get it properly set up
Cheers

[paxo]

Quick question.....when wiring in the PC do you just splice it onto the existing loom and leave the original wires still connected to the ECU etc......... or do you cut the existing loom and completely disconnect the original connection....if you get my drift !???

Cheers for the help Kawasakiman......ive manually typed in that map for the 370cc injectors and its now nicely on the PC, so if anyone wants a USB map for 370 injectors and doesnt want to have to sit and type it all in by hand.......just let me know and i will send you it

Paxo

[Lorcan]

http://www.750turbo.com/forum/viewtopic.php?f=13&t=4790

Nothing gets disconnected going "into" the ECU.

The injector output wires from the ECU go VIA the PC, and the boost sensor wire is shared by both the ECU and the PC.