Power commander wiring

[FastFerret]

As a prelude to going the PCIII/PCV route, does anyone have or is willing to make up a wiring breakdown diagram?
Basically, PC wire x goes to ECU/CDI/WiringLoom wire Y etc.

Is it at all possible to do this? Do the Power commanders have common wiring colour configurations?
Is it already somewhere on the site?
Can we put something into the 'How to' section regarding this?

Thanks gents.

[kawasakiman542]

FF,
Lorcan has provided the basic format for the PC if you look up PC installation,M6ntl (Mark) has provided the needed diagram for the 5v calibration to the power commander and the 6v cap for the ECU to prevent overboost.Here's the thread;

http://www.750turbo.com/forum/viewtopic ... ode#p68041

[FastFerret]

Thanks KMan, I found the thread.
Still think it should be a 'HOW TO' though.

[Lorcan]

It will be one day

[aussie750e1]

I agree with ferett,to me wiring the pc111 thread is as clear as mud "dumb fck".

Is there a,or can someone post a "simple DIY" diagram or photo's for dummies like myself ?

Totally confused...Dave

[Chris G]

I agree with ferett,to me wiring the pc111 thread is as clear as mud "dumb fck".

Is there a,or can someone post a "simple DIY" diagram or photo's for dummies like myself ?

Totally confused...Dave

I must be your cerebral twin
How to would be dead good tho

[Piney Power]

When I get ready to do mine, I'll ask some specific questions in the Install thread about where folks intercepted which wires, keep the camera handy, and try to type it up.

[Lorcan]

Eckhard has volunteered to write it up over the weekend

[Chris G]

Nice one Eckhard - English as well as French?

[wobbles]

Eckhard has volunteered to write it up over the weekend

So if get written up over the weekend does that mean it will then only be three short years before it makes it to the "How To" page :

[Lorcan]

[Bigredzed]

Powercommander XXV will be out before a "how to" gets posted

[kawasakiman542]

Tread lightly gents,unless you are volunteering your time to get it done.

[Eckhard]

I started doing it and there is a lot of info I could put in there but I'll try and stay with the essentials. Right now I am working in Microsoft Word. Anyone have any suggestions for a HTML writer type software???? Or maybe Word will let me save it with HTML tags.

[satriani]

hey french canadian dude do you have a pc 3 on one of your bikes if so im anxious to see in detail how to install one..and by the way did you buy one of your bikes from a guy in cambridge ont.