Injektor Parts

[Würstchens-Turbo 810]

Hello friends,

I'm looking for the rubber parts for the fuel injectors:

4 x 92055-1082

4 x 92075-1240

Unfortunately, they are no longer available. Have any of you found alternatives?

The wide rubber part at the top isn't a seal, is it? It's just a spacer, right?

Regards, Horst

[JezZedexE1]

Hi Horst.

I am sure there are seals available that fit and will be new to buy. Maybe Charlie can help with some makes and part numbers.

If not, this is listed on ebay in Dortmund, Germany and may help.I am sure the parts you need will be the same size as what is on these.

See if you can make a deal with the seller or sell the bits you do not need

167642846696

[Würstchens-Turbo 810]

Hi Horst.

I am sure there are seals available that fit and will be new to buy. Maybe Charlie can help with some makes and part numbers.

If not, this is listed on ebay in Dortmund, Germany and may help.I am sure the parts you need will be the same size as what is on these.

See if you can make a deal with the seller or sell the bits you do not need

167642846696

Thx
do you have a ebay-link ?
i dont found anything there in Germany

[rangeroy]

have you tried these boyz? they maybe could help
https://injectorzone.de/

[riturbo]

some on U.S. ebay . Stupid money though. You should check with Charlie. They must get them cheaper as they must change them out when he gets injectors rebuilt.

https://www.ebay.com/sch/i.html?_nkw=Ka ... m570.l1313

https://www.ebay.com/sch/i.html?_nkw=Ka ... &_osacat=0

[JezZedexE1]

do you have a ebay-link ?

Ebay item number 167642846696.

https://www.ebay.co.uk/sch/i.html?_nkw= ... &_sadis=15

[Philb]

Anyone got the size of these seals?
I might be able to get some molded.

[JezZedexE1]

The 92055 will need to be pretty accurate, as it goes into the T/B's. (I think)
92075 not so critical, but I may be wrong.

026222.jpg (31.51 KiB) Viewed 2936 times

If you have a spare injector lying about, you will be able to size them.

[JonesDk]

I need 4 injectors for my build.
I would like Bosch, but any good working would do for a start.

Where in Europe can I get the correct plug and play injectors?
Around 300cc would be good.

Is there any producers that make straight out replaceable injectors?
Or is it possible to have some shipped to Denmark?

Kind regards
Jonas

[JonesDk]

I have checked with the part numbers and producers, no luck on europe. Bosch do not have a replacement in production they said.

Do anybody know of it is possible to get new injectors in EU? I would like some asap, but can wait and have shipped from US if not able to get.

Where to buy new ones in the US? Ultimo June 2026.

Kind regards
Jonas

[SilveradoKC]

I ordered and received the injectors that Charlie recommends for modified builds just recently here in the states

Part number 2-18506

[JonesDk]

I am looking for standard injectors or as close to as possible.