PC5 Individual Cylinder Fuel Trim?

[Art]

I'm using a PC5 (for a 2004-08) Suz GSXR750. In the "Control Center" Windows software, I cannot find a mechanism for individual cylinder fuel trim, like the PC3. Is this feature supported on the PC5? I need to compensate for the slight variations in flow rates across the four injectors. Any guidance would be greatly appreciated.

[Art]

I figured it out. I may be the only one who didn't know this, but just in case, here's what to do in Power Commander Control Center (V1.0.6.4):
Map Tools > Advance/Demote Map > change Fuel Tables (TPS or Pressure) from Basic to Cylinder Advanced. Now you can program individual fuel tables for each cylinder. Way more than just injector calibration trim, but that's what copy and paste are for. Note that if you import a pre-tuned table that did not have individual cylinder tables, it will remove the individual cylinder tables, reverting to the single imported fuel table.

[Charlie @ Evergreen]

Thats good information! Mang? Were you not looking to do this? Or did you already on your PC ?

[Mang]

I was hoping to do this but when i did a plug chop all was good so never needed to do it.