Percentage changes to PCV fuel table

[Mang]

Is it possible to select a 'block' of trims in the PCV fuel table and raise or lower the 'block' by a percentage value?

Also is there a "rule of thumb" for percentage increase/decrease from AFR readings, say the AFR is reading 12 then what percentage should I raise it by to get to say 13.5?

[turbo_Rob]

I see this is a little old but....

I would think if you copied it to an excel file you could us a formula to change then paste back to the PCV.

[Mang]

Thanks for reply Turbo Rob.

In the interim I found out how to do it. I am not a the computer with the Power Commander program on it so i will look up later and post.