Megacycles gpz turbo cam

[zedturbo]

Had anyone tried it? Only a few degrees of overlap, short duration but 10mm lift.

Megacycles cams turbo.pdf

(631.95 KiB) Downloaded 426 times

[Turboblew2]

no direct experience but a friend that had a pretty fast turbo had that cam. Definitely good for more torque/hp.

[Lorcan]

Not tried Megacycles but have used reprofiled ZX750A cams which have more lift. Jeff ran a thread about this a few years ago. If I remember rightly, regular Z750E/L cams were a good compromise.

[DEATH_INC.]

Be careful....pretty sure 9mm (352" or thereabouts) is about as much as stock springs can handle...don't ask how I know...(edit...it says use springs duh)
Also from the flow testing I did flow on a ported head stops going up at around 350" too.