Wrapping Header Pipes with Heat Wrap

Make it quick...and reliable

Wrapping Header Pipes with Heat Wrap

Postby ickyoldman » Fri Jan 31, 2020 9:36 pm

Has anyone done this? Notice any performance difference? Any drawback?
ickyoldman
Member
 
Posts: 15
Joined: Sun Jan 05, 2020 10:52 pm
Location: Richmond, IL

Re: Wrapping Header Pipes with Heat Wrap

Postby Charlie @ Evergreen » Sat Feb 01, 2020 12:39 pm

You won't notice any difference. If you did you would have to gain some hp from a header wrap. More to keep heat off components to not damage them. The header/turbo being wrapped could cause pre mature failure of the parts (header & turbine housing both cracking) as seen this on other performance wrapped turbine header & turbine housings. They crack severely inside the diffuser area from excessive heat. Remember these turbine housings are (oops...my fault ! usually ) vernally cast iron with high nickel content in manufacture. :thumbup
84' ZX750 Turbo 85'ZX750 Turbo
User avatar
Charlie @ Evergreen
Intercooler
 
Posts: 6492
Joined: Sun Nov 17, 2013 12:20 am
Location: Ocala, Florida USA

Re: Wrapping Header Pipes with Heat Wrap

Postby Eckhard » Sat Feb 01, 2020 3:44 pm

vernally cast iron


What is this material?

:rofl: Sorry Eckhard! My eyes are horrible I swear!! I corrected the comment above... ;)
Did I make a new word ?
Eckhard

A garage full of old bikes and no time. Spend too much time on the Internet!!!
User avatar
Eckhard
Supporter
 
Posts: 1095
Joined: Tue Feb 05, 2008 2:46 am
Location: Chateauguay, Quebec, Canada


Return to Street Tuning

Who is online

Users browsing this forum: No registered users and 4 guests