Duty cycle

[Würstchens-Turbo 810]

Hi how important is the "Duty Cycle" in the PCIIIusb Software for us ?

I dont understand this

[mankam]

it's never too late for an answer

“Duty Cycle” displays the percentage of time the injector is open during one cam revolution (fuel cycle). In advance mod, it's the percentage of time for each cylinder's duty cycle. Without the Power Commander, the Duty Cycle is controlled by the ECU


Here is a video that explains:

[Würstchens-Turbo 810]

Hi Thanks .
My (the) Power Commander3usb not shows a Duty Cycle Area.
But i use the innovate SSi-4 Box for Data recording and this Box can show Duty Cycle but i dont know how ,
i dont know which wire , out from Injektor ) is positiv and which is ground .
Pur Injektors open by ground or open by + . ?

[DEATH_INC.]

Injectors are normally controlled by the - or negative (ground) wire. The + positive one should power up when the key is turned on.
- wire is yellow on the stock bike, and + is red/white.

[Würstchens-Turbo 810]

Thank you very much

[Würstchens-Turbo 810]

hi again after a few years
Please how to show Duty cycle in my PC3 usb
i see only

throttle
upm
Fuel change
zyklus ( what is it ?)

[Würstchens-Turbo 810]

hi again after a few years
Please how to show Duty cycle in my PC3 usb
i see only

throttle
upm
Fuel change
zyklus ( what is it ?) Edit >> ITS Duty Cycle

[Charlie @ Evergreen]

Hopefully someone with experience in PC will answer soon Horst