ZX9r-ZX6r Axle size?

Update the rear to put the power down

Re: ZX9r-ZX6r Axle size?

Postby Würstchens-Turbo 810 » Sat Jan 27, 2018 4:32 pm

tack1000 wrote:I could not find all the parts, but this is the important bit, me thinks.

Image

You remove the inner air box and replace it with the plate.

Image

The slave cylinder fits in the remaining air box.

The ZX750 sprocket seal cover is different than the early covers with the boss for the push rod. That's why I has to weld the boss on and fit a seal.
The push rod is cut to length and use the end cap with the hole in it Or drill a hole. The clutch side is straight from a ZRX1100.

It was a while back I made this (6-8 years) but that's roughly how its done.


i cant open the pics :oops:
User avatar
Würstchens-Turbo 810
Intercooler
 
Posts: 1408
Joined: Fri Feb 15, 2008 7:57 pm
Location: Bremen / Germany

Re: ZX9r-ZX6r Axle size?

Postby tack1000 » Sat Jan 27, 2018 7:08 pm

I think these are the pics you are after:

FUJIFILM FinePix6900ZOOM_20070702_065816.Id_339118.jpg


FUJIFILM FinePix6900ZOOM_20060129_145835.jpg


FUJIFILM FinePix6900ZOOM_20060129_145852.jpg


FUJIFILM FinePix6900ZOOM_20060129_152938.jpg
User avatar
tack1000
Supporter
 
Posts: 3257
Joined: Wed Jan 22, 2003 10:19 pm
Location: Ipswich England

Re: ZX9r-ZX6r Axle size?

Postby Würstchens-Turbo 810 » Sat Jan 27, 2018 8:29 pm

Thank you , Tack
This is very interesting
i like to learn more about this clutch-work , but from where ?
User avatar
Würstchens-Turbo 810
Intercooler
 
Posts: 1408
Joined: Fri Feb 15, 2008 7:57 pm
Location: Bremen / Germany

Previous

Return to Rear end swaps

Who is online

Users browsing this forum: No registered users and 1 guest