750turbo.com

I asked about the throttle bodies because the same thing happened to me after I had upgraded the whole fuel system

Total shut down with DFI blinking
Computer was flashing code 11, which had to do with the throttle bodies not having the stopper (which was just a screw) on the throttle- allowing it ...

It sounds like a momentary complete electrical failure.
Pickups on the right side (check the wiring and harness connector near the fuel filter (disconnect and reconnect several time to scrap the contacts)
The igniter (check all connections...same as above)
Computer not much to offer here
Coils ...

SilveradoKC wrote: ↑Sun Oct 04, 2026 11:08 pm Question
Do you have the 1100 throttle bodies?
Did you check the code?
KC

yes 1100er Bodies since many years
Unfortunately, I forgot to check the blink code.

Hi,
I went for a ride yesterday and wanted to test how the bike handled at high speeds (over 200 km/h) with the new tires.
To start with, everything was fine on the country road—boost pressure was around 1.4 bar, and acceleration was great.
Then I got onto the highway; I had dialed the boost down to ...

JezZedexE1 wrote: ↑Mon Sep 21, 2026 11:25 am

do you have a link to your videos ?

viewtopic.php?p=193569#p193569

A variety of links in this post.

thx

rangeroy wrote: ↑Mon Sep 21, 2026 6:50 am As kawadoodle says throttle bodies fully open and I bet your problem will be solved

Well, it’s definitely getting better, but it probably won’t resolve the stark differences between them.

do you have a link to your videos ?

Do you know what a cylinder leak-down test is?
If you have the chance, I would do that first.
Then you'll know why the pressure is missing and where it's escaping.

very nice , congrats

This is unrelated to the question above.

Perhaps someone has an idea:
After switching on the ignition, the pump builds the fuel pressure up to the set 2.3 bar; however, as soon as the pump stops running, the fuel pressure drops immediately. (The engine is still off.)
Shouldn't the pressure be ...

Are you all on vacation?

Hey everyone,
just looking for a point of reference, what tire pressure do you run on modern 17" tires?

I'm currently will running Michelin Road 6 (120/170), which has a pretty soft sidewall.

Since I'm using the entire front end of a ZRX1100/1200, I looked at that as a guide, and the ZRX only gets ...

no idea ?

Okay, 18/50 (2.77) at 530 chain seems quite long to me; the original is 3.06.

I currently have 15/46 with 630 chain and 17" wheels with 170/60 tires (3.06).
I find my current setup geared a bit too short, too stressful (for 17" wheels and around 200 hp).
But only a little; I don't need a very high ...

Hi Horst.

I am sure there are seals available that fit and will be new to buy. Maybe Charlie can help with some makes and part numbers. :popcorn

If not, this is listed on ebay in Dortmund, Germany and may help.I am sure the parts you need will be the same size as what is on these.

See if you ...

Hello friends,

I'm looking for the rubber parts for the fuel injectors:

4 x 92055-1082

4 x 92075-1240

Unfortunately, they are no longer available. Have any of you found alternatives?

The wide rubber part at the top isn't a seal, is it? It's just a spacer, right?

Regards, Horst